Y-shaped skirt double-layer composite anti overflow skirt guide groove skin protection

 
The anti overflow skirt of the guide chute is a double-layer structure, which is installed on the lower edge of the guide chute of the belt conveyor through a set of fast pressing device for sealing between the conveyor belt and the guide chute
1
Double layer sealing, inner isolation, material overflow, outer suppression of dust flying
2
Polyurethane wear-resistant layer is compounded at the part in contact with the belt, which has long service life and does not damage the belt
3
The quick pressing device makes the installation and adjustment convenient and fast
Installation instructions: 1
The gripper is used with angular aluminum, and two sets of grippers are used per meter
2
The height of anti overflow skirt can be adjusted according to the actual size of guide chute

Size range
Y-type overflow apron 150mm-350mm ,
  T-shaped anti overflow Skirt 150mm-300mm  
  The technical features of double seal anti overflow skirt are as follows:
1
Skirt material: it is made of polyurethane and rubber, and the part in contact with the belt (playing the main sealing role) is polyurethane
Polyurethane is made of powder casting, which has better wear resistance, longer service life and no damage to the belt than polyurethane made by extrusion process

2
Sealing effect: the anti overflow skirt adopts the double-layer sealing integrated structure of straight plate and skirt edge
The straight plate is close to the side of the guide groove, and the bottom is in contact with the belt to prevent material overflow; The skirt is turned out and can rotate within a certain angle
Relying on the elastic force of the rubber plate, it automatically * the belt, always in close contact with the belt, with excellent sealing performance

3
The skirt sealing part of the skirt adopts unilateral arc transition
When the belt deviates, it will not hurt the belt and skirt, and can automatically restore to the original state

4
The skirt at each side of the guide chute shall be made into a whole as required, which shall be the same length as the guide chute to prevent air leakage at the joint

Problems existing in the sealing of ordinary guide chute
At present, the sealing strips on both sides of the guide chute are mostly cut by ordinary rubber belt and fixed with the guide chute through angle steel, wedge-shaped locking device, etc
The main problems of this sealing method are:
1
Poor wear resistance of sealing strip
After a short time of use, it is seriously worn, the sealing strip can not be in close contact with the belt, the sealing effect is poor, the phenomenon of air leakage and powder running is serious, the site dust is large, and the environment is bad

2
The sealing strip has no upper and lower deformation
Once the sealing strip installed under the static state of the belt is fixed, when the belt is loaded with material and has a sinking amount, the sealing strip will have a gap with the belt, and the phenomenon of coal spraying and powder running is serious

3
The sealing strip is single seal, which is not as good as double seal

4
The workload of replacing the sealing strip is heavy

  Long tail anti overflow Skirt , Short tail overflow Apron Belt conveyor overflow Apron Flat anti overflow Skirt Guide chute Skirt Belt conveyor baffle , Anti overflow skirt installation Price and size of overflow Apron Rubber spill Skirt , Jining anti overflow Skirt , Polyurethane spill Skirt , Guolong anti overflow Skirt , Guide chute anti overflow Skirt , Double layer composite anti overflow Skirt , Gripper , Spill apron retainer , T-shaped anti overflow Skirt , Polymer anti overflow Skirt High wear-resistant anti overflow Skirt Y-shaped anti overflow Skirt All polyurethane anti overflow skirt
Contact: manager Liu
Mobile: 18754797346
Tel: 0537-3368198
QQ No
: 2530973981