Spillproof skirt retainer galvanized retainer guide groove cove

  Guide chute anti overflow skirt Holder Stainless steel Galvanized Holder Special holder for rubber plate clip anti overflow skirt
1
The gripper is used together with angle aluminum, and two sets of grippers are used per meter

2
The height of anti overflow skirt can be adjusted according to the actual size of guide chute

Gripper: the looseness and tightness of the fixed clamp are adjusted by screws
The aluminum alloy fixed angle steel is connected with the fixed clamp to avoid falling due to loose screws

 
  Simple installation method: A: butterfly nut type B: Handle type

  Quick fixing of the skirt by means of angle aluminium, retainers, etc
:
 
1
Angular aluminum (40mm & times; 40mm) is pressed and formed at one time
Material: all aluminum, beautiful appearance, no rust
It is a circular column, locked in the holder without falling off

2
The base of the gripper is welded outside the side of the guide groove, and the slide goes deep into the base to make the gripper move properly left and right along the base

3
Manually rotate the compression handle and push it up (down) to the bottom when appropriate
Enough pressure can be applied to the diagonal aluminum to maintain the skirt position, and the compression handle will not loosen and fall off

4
The gripper adopts hot-dip galvanizing, with light weight, good anti-corrosion performance and no rust

5
The fastening bolt is made of stainless steel 304, which will never rust
It is suitable for use in dark, humid or even short-term water flushing environment

6
Except that the holder base needs electric welding during one-time installation, the skirt shall be replaced in other processes and in the future without any tools
The installation and disassembly are very convenient and fast
Contact: manager Liu
Mobile phone: 18754797346 (same as wechat)
QQ No
: 2530973981