LPMs 900md turntable hot runner type multi rubber cylinder fast melting integrated low pressure glue injection machine

  The top type low-pressure glue injection machine series is more reasonable and reliable for the design of left and right parallel continuous wire outgoing die
It is suitable for all kinds of low-pressure hot-melt adhesive molding resin to inject and seal products
Low process pressure (0-6MPa), no damage to parts, no chemical reaction, rapid forming, cooling and forming
After forming, the product has the properties of insulation and waterproof
Widely used in: battery, sensor, coil, harness, connector, PCBA and other encapsulation

l  Rotary table, one upper die corresponds to two lower dies, with high production efficiency
l  It can be set with single lower mold production or double lower mold production, which can be used flexibly
l  Quick melt rubber cylinder, take 6208 hot melt rubber as an example, heat it at 200 ℃ for 18 minutes
l  Built in double rubber cylinder, which can produce different colors or different models of rubber
l  The hot runner system can effectively shorten the distance of the mold runner, save the rubber cost and improve the beauty of the product surface
l  The equipment has built-in cold water system, which is convenient to use and improves efficiency
l  The glue injection pressure is controlled by the electromagnetic proportional valve, and the glue injection pressure is directly adjusted on the operation screen to control the pressure more accurately
l  The components of the glue injection system adopt modular design, which makes the repair and maintenance convenient and fast
l  Self diagnosis function and various fault alarms
l  Multi stage temperature control, rubber cylinder, rubber hose, hot runner and hot nozzle can be controlled independently
l  Timing heating, overtemperature alarm and automatic stop heating function
l  Automatic feeding system and rubber dryer (optional) to improve work efficiency
l  Standardized and systematic mold base design makes it easy to replace the mold
l  Equipped with product ejection device, it is convenient to take out the product
l  The work protection adopts two hand photoelectric induction switch and grating, and the taking and placing products and opening and closing molds are not in the same station, so the operation is safer