GLD belt feeder also produces non-standard lengthened coal feede

  I'm Dongda mine safety salesman: Manager Wang , Tel: 13325190775 (same as wechat)
Company name: Shandong Dongda electromechanical Co
, Ltd
Address: South Shanbo road and West Zhixue Road, Jizou Science Park, high tech Zone, Jining City, Shandong Province
GLD series belt feeders are divided into belt type, a-belt type, manual gate type, hydraulic cylinder gate type, manual adjustment type and frequency conversion adjustment type
Our company not only produces GLD series standard a-belt coal machine, but also produces non-standard and extended a-belt coal machine

Main structural features of gld800 / 5
5/s a coal feeder
1
Low operating power, low energy consumption and good economy;
2
The coal feeding quantity of the coal feeder brought by Party A is large and stable;
3
Dynamic adjustment, stepless speed regulation and convenient adjustment;
4
The coal machine brought by Party A operates stably, has low noise and protects the environment;
5
Small wear, small maintenance and long service life;
6
Strong universality of parts and convenient installation and maintenance;
7
The coal feeder brought by Party A can replace other existing types of coal feeders

The main models of a-belt coal feeder are
Gld800 / 5
5/s a coal feeder gld800 / 5
5/b a coal feeder
Gld1500 / 7
5/s a coal feeder gld1500 / 7
5/b a coal feeder
Gld2200 / 7
5/s a coal feeder gld2200 / 7
5/b a coal feeder
Gld3300 / 7
5/s a coal feeder gld3300 / 7
5/b a coal feeder
Gld4000 / 11 / s a coal feeder gld4000 / 11 / b a coal feeder
Belt coal feeder Manually adjust coal feeder A Hydraulic cylinder adjustment a coal feeder Frequency conversion coal feeder
Daily repair and maintenance of GLD belt a feeder
1
After continuous work every month, check whether the parts are loose or abnormal
2
When the feeder is used, enough coal shall be stored in the coal bunker to avoid direct impact on the bottom plate when coal is loaded into the bunker

3
  The transmission parts shall be inspected every six months of continuous operation
The parts of the pull rod must keep normal cooperation
If there is any abnormality, it shall be repaired or replaced immediately

4
  All rotating parts are required to be oiled once a month and inspected once a quarter, observe the damage degree of bearings and seals, and replace them in time in case of problems

Maintenance of main parts of gld4000 / 11 / b a belt feeder:
Reducer: check once every six months, and clean the rolling bearing and box or replace the lubricating oil at the same time

Motor: according to the maintenance requirements of the motor

Attention of users: lubricate the moving parts regularly and check the operation of each part
If any abnormality is found, find out the cause and deal with it in time
The manufacturer can be notified to deal with it when necessary; The gate shall be closed during empty warehouse maintenance