Supply hardware and machinery rust inhibito

1017-b rust inhibitor
Introduction: This product is a light yellow to brownish red liquid, which is not easy to burn
It is composed of a variety of antirust agents, concentrated corrosion inhibitors and other additives
It is a water-soluble antirust agent prepared according to the formula proportion under special process conditions
It can be miscible with water
Compared with traditional antirust oil, it eliminates the adverse impact of antirust oil on subsequent processes
It is applied to antirust treatment of hardware products, antirust treatment of processes and electroplating antirust, Electroplating passivation treatment

Application: suitable for rust prevention between various processing procedures, semi-finished products or finished products in the process of hardware machinery manufacturing and maintenance
It has been used in hardware manufacturing, surface treatment, electroplating and other industries

Operating parameters:

usage concentration (this product: tap water)	workpiece surface state after treatment	reference value of antirust period
1：100	dryness	more than 7 days (non electroplated workpiece)
1：20	slightly oily	more than three months (non electroplated workpiece)
1：9	oily	more than one year (non electroplated workpiece)

usage: select the relative concentration according to the actual situation, dilute it with clean water, stir evenly, and then use it
The working fluid temperature is normal temperature - 60 ℃, and the workpiece is soaked for more than 1 minute
Shake the workpiece slightly during soaking, and dry it naturally after soaking
Never wash it with water

Note: the above data is for reference only
(it will vary due to different workpiece materials and storage environment)
You can choose the appropriate operating concentration according to your actual situation
The processed workpieces shall not be exposed to moisture and shall not be stored in a wet place

Operation process: workpiece electroplating (or pickling and degreasing) → Water washing → 1017 treatment & rarr; Drying (or natural air drying) - Packaging
Common faults and Solutions

fault phenomenon	reason
the product is rusty after treatment	1 the concentration is insufficient, 2 the working fluid is seriously polluted, 3 the drying temperature is too high, and 4 the soaking time is not long enough
the working fluid is seriously turbid	it has been used for too long and is seriously polluted It is recommended to replace it

note: sometimes the appearance color of this product is a little light yellow, sometimes a little brown red, and its antirust effect remains unchanged
Please rest assured to use it

Storage: cool and ventilated, away from fire source
Statement: the contents and suggestions of this manual are based on the experimental data of our company; Due to the differences in operation and equipment among users, the company does not make any warranty for the results of the use of relevant products of the company, nor is it responsible for the damage caused by adverse results
All materials in this manual shall not be used as a basis for copyright infringement