Quasi dry micro lubrication energy saving equipment

  With the development of metal cutting, the requirements for micro lubrication are increasing
According to the current situation, our company has recently developed ks-2107 oil, gas and water three-phase composite lubrication and cooling system
You are welcome to adopt ks-2107 oil, gas and water three-phase composite lubrication and cooling system
It not only indicates that your production environment has been improved, but also means that you have introduced an advanced cutting method
The equipment integrates the lubrication and cooling advantages of oil, gas and water
If the operation technology is appropriate, the cooling mode provided by this product can not only improve the processing efficiency and prolong the service life of the tool, but also improve the processing quality of the product and beautify the environment
Before using this equipment, please read this manual carefully and keep it in an easy place

1、 Product name
Ks2107 oil gas water three-phase composite lubrication cooling system
2、 Principle characteristics
According to the principles of oil chemistry and interfacial chemical reaction, the oil molecules that can naturally degrade the oil agent have hydrophilic groups (negative ions) and hydrophobic groups (cations), and the oil molecules will be adsorbed on the water interface side by side one by one
Due to the expansibility of oil molecules, the result of thousands of oil molecules adsorption is to form a thin oil film on the interface of water molecules, so as to form oil film and water droplets
A small amount of vegetable oil and a small amount of water are atomized through compressed air and special nozzles and form tiny water droplets (100 ~ 200 & mu; m) with a thin oil film (about 0
1 & mu; m) adsorbed on the surface, that is, oil film attached water droplets

Under the action of compressed air, the oil film with water droplets is sprayed to the cutting area at a certain speed, so as to cool and remove chips
Due to the expansibility of the oil film on the surface of water droplets, the oil film that initially reaches the surface of the workpiece can fully lubricate and reduce wear, so as to produce good lubrication effect
In addition, after the oil film water droplets enter the cutting area, they absorb the cutting heat and form a vaporization center, which takes away a large amount of heat
The small water droplets generate phase change and become steam, which improves the heat dissipation capacity
The oil agent is adsorbed on the machined surface, which has a good lubrication and rust prevention effect
The proportion of water and oil in the fog can be adjusted at any time according to the processing needs

& ldquo; Water & rdquo; It can be antirust water or low concentration water-soluble micro cutting fluid
Low concentration water-soluble micro cutting fluid has better machining and rust prevention effect