Pulse dust collector equipment

Operating procedures for maintenance of pulse dust collector:
1
Basic maintenance methods:
(1) during equipment operation, special personnel shall be assigned for management and operation records shall be made

(2) the management personnel shall be familiar with the principle, performance and service conditions of the dust collector, and master the adjustment of operating parameters and equipment maintenance methods

(3) regularly add lubricating oil to the parts that need to be lubricated on the equipment

(4) regularly check whether the pulse ash cleaning system of the dust collector is blowing normally
If not, focus on checking whether the pulse valve diaphragm and solenoid valve are out of order or damaged, and repair or replace them in time

(5) if the pulse valve breaks down, it should be removed in time
If there are impurities, water and other foreign matters inside, it should be cleaned in time
If the diaphragm is damaged, it should be replaced in time

(6) regularly check the cylinder and each flange surface
If air leakage is found, replace the sealing ring in time

(7) if the sealing strip on the access door is aged, it shall be replaced in time

(8) regularly measure process parameters, such as gas volume, temperature, concentration, etc
if any abnormality is found, find out the cause and deal with it in time

(9) regularly check whether the equipment operates normally according to the change and fluctuation of equipment operation resistance

(10) the filter bag is a vulnerable part
The user shall regularly check the working condition of the filter bag and consider replacing it in time according to the damage degree of the filter bag

(11) regularly check the working conditions of the gas path system and ash discharge system, and timely eliminate any abnormality

(12) regularly drain the accumulated water according to the accumulated water in the water separator of the compressed air system

(13) during shutdown, after the process system stops, the dust collector and exhaust fan shall continue to work for a period of time to remove moisture and dust in the equipment
At the same time, the dust cleaning and unloading operations must be repeated before the dust collector stops working
(source: http://www
qyhgsbcj
com/products/99
html ）The