Linear motor coil potting glue

 
1  purpose
 
  Lk444 linear motor potting adhesive is a two-component adhesive, which is composed of main agent and curing agent
It is used in linear motor, electric appliance, waterproof transformer, motorcycle igniter, anion generator, aquarium and other products for waterproof, moisture-proof, anti-corrosion, sealing, filling, heat conduction and insulation

 
2  Product characteristics
 
2
1  Comply with ROHS environmental protection requirements
 
2
2  Flame retardant grade V0, thermal conductivity up to 1
0W / M
K
 
2
3  Excellent temperature resistance range (- 60 ~ 160 ℃)
 
2
4  Excellent insulation and aging resistance
Waterproof and moisture-proof, good deep curing
 
3  technical parameter
 

	result
Project
	main agent		curing agent
appearance	black viscous liquid		light yellow liquid
appearance (after curing)	Black
viscosity (MPa S)	4500± five hundred		100-250
specific gravity	1 65± zero point one zero		1 06± zero point zero five
mixed viscosity (MPa S)	2500± five hundred
specific gravity after mixing	1 40± zero point zero five
operable time (hours)	24
curing time (60 ℃) (minutes)	30-40
curing time (25 ℃) (hours)	＞72
thermal deformation temperature ℃	140
hardness after curing (Shore D)	85-90
usage ratio	4:1
bonding strength (MPA)	＞20
surface resistivity: (& omega;)	1 4× one thousand and fourteen
volume resistivity: (& omega; Cm)	1 0× one thousand and fourteen
dielectric strength (kV / mm)	18

 
4  usage method
 
4
1  Measurement: accurately weigh components a and B (fully mix components a and B before weighing to make them slightly
 
The filler with sedimentation is evenly dispersed in the glue solution)
 
4
2  When using the main agent and curing agent, special equipment shall be used to mix evenly according to the specified proportion
 
4
3  Glue mixing: add component B to component A and mix evenly
 
4
4  Defoaming: place the evenly mixed rubber in the vacuum cabinet for defoaming
 
4
5  Pouring: pour the defoaming rubber into the parts to complete the pouring operation (part surface and mixing before pouring)
 
Shared containers should be kept dry and clean)
 
4
6  Curing: place the potted parts in room temperature or heating environment (heating to 60 ℃) for 30-40 minutes
 
Minutes) allow the compound to cure
 
5  Safety precautions
 

5 1	please refer to our product instructions and MSDs in detail before use
5 2	the construction site must maintain good air flow
5 3	wear protective equipment, such as goggles, special gloves, shoes and hats
5 4	avoid contact with skin and eyes If you enter your eyes by mistake, please wash them with clean water immediately and see a doctor if necessary
	student; In case of skin contact, please wipe it off with a dry towel and wash it with soap
5 5	this product is for industrial use only

 
6  Storage and protection
 
6
1  Don't put it in direct sunlight, put it in a cool and ventilated place
 
6
2  Keep this product out of the reach of children
 
6
3  This product is non-toxic and non *, according to general chemicals