Huai'an what is a warm body dummy

  Thermal manikin - the thermal manikin consists of 34 independently controlled hot zones
The division of manna area is shown in Figure 1
3
1 below
All hot zones are equipped with heaters to simulate the metabolic heat output rate, and distributed wire sensors are used to measure skin temperature
In addition, each hot spot can control sweat through fluid ports evenly distributed on its surface
There is a fluid heater inside the manikin to pre heat water, which is then distributed to the ports on the manikin surface
1
power indicator - DC power form has an indicator
Note: VHTR can only be activated when the manikin is running normally and the thermodac software is running
2
heater voltage adjustment dial - this allows the user to reduce the heater voltage from the nominal setting of +48v
A lower voltage may be required when testing highly insulated clothing, or in any other case where a lower heat flux is required to maintain temperature
The heater power is determined by the formula p= (v2/r) D
C
(d
c
= heater duty cycle), so ½ of the voltage is reduced; The maximum available heater power will be reduced to the rated ¼
3
do not block the fan vent! These devices provide ventilation for the manikin power supply
4
serial port - this is the interface from the 9-pin serial port cable to the thermodacpc
5
heater and sensor connectors - these field cables are plugged into the two connectors on the hot manikin
6
power connector - AC power is provided here
The acceptable range is 85265vac, 2KVA
7
power switch switch
The power input module (PEM) also contains two AC input fuses
Pump housing - the pump housing contains a pump, UV, filter, and pressure regulator to control the flow of water to the manifold