Brief introduction and parameters of hydraulic splitting rod of electric hydraulic splitting machine

  Brief introduction and parameters of hydraulic splitting rod of electric hydraulic splitting machine in Guigang, Guangxi I
working principle:
Hydraulic splitting machine is the * product of our company
It is based on power station (including electric power station and
The high-pressure hydraulic oil generated by diesel engine (power station) is used as the energy source and transmitted to each splitting machine through oil pipe
The oil cylinder tube, also known as splitting, controls the push and expansion of the piston rod in the splitting machine, and skillfully responds to
The wedge principle is used to make the stone splitting force reach hundreds or even thousands of tons, while the rock and concrete
The external compressive strength is very large, but the internal tensile strength is relatively limited, which is due to each other
Because of these characteristics, the huge stone can be easily split by the splitting machine in a few seconds to make the hard ore
From the mountain

2
Operation process of operation steps:
1
Set splitting points on the rock or concrete to be broken with air * or hydraulic rock drill and other equipment
And drill holes

2
Evenly apply lubricating grease on the contact surface between the splitting block and wedge of the splitting machine to reduce the damage of the splitting machine
Working resistance

A
when purchasing the machine, we will deliver a barrel of special lubricating grease (1kg per barrel), which can be used
3-6 months)

3
Open the power station and turn the manual valve on the power station to the working gear I or II, the same as
Open the manual valves on all splitting machines to the working gear I or II to determine the wedge of the splitting machine
The running direction of the actuator

4
Insert the splitting machine into the hole of rock or concrete, open the working gear of manual valve and start splitting
a
The single * splitting section can reach 1m2 or more

B
the harder the rock is, the weaker the tensile strength is, and the better the splitting effect will be

C
each splitting time is 8-15 seconds

D
features of hydraulic splitting machine:
1
The product is light, easy to operate and safe to use
The weight of the splitting machine is about 25kg, which can be light by one person
Loosening operation; Single manual valve control, ordinary workers can use it skillfully after one operation; During work
It will not produce dust, noise and vibration, so it is very safe

2
Mature technology and reliable quality
Farun's strong capital strength and scientific research strength provide support for the development of products
Continuous upgrading and improvement provides strong support
Now the hydraulic splitting machine is the main product of our company
, the product quality has reached the international leading level

3
High work efficiency and outstanding cost performance
The hydraulic splitting machine has a splitting force of nearly 900 tons, once
The splitting section can reach more than 1 square meter
With more than * thousands of tons of splitting force, the next piece can be split in about ten seconds
Jushi, and compared with similar products at home and abroad, its cost performance is outstanding
　　
Precautions for use of hydraulic splitting machine
In order to make you better use of our hydraulic splitting machine and avoid undue failure of the hydraulic splitting machine
Please pay attention to the following items and strictly abide by them when using the splitting machine:
I
after the hole depth reaches the standard, the splitting machine can be inserted into the hole for splitting
(the hole depth shall be
: the length of the splitting block at the front end of the splitting machine is more than 300mm
For example, if the splitting block is 250mm long, it must be drilled
Only holes with a depth of more than 550mm can use the splitting machine)
II
After each splitting machine splits 3-5 holes, apply a certain amount of grease to reduce wedge and splitting
Friction between blocks

III
It is strictly prohibited to use the splitting machine * head as a crowbar