Weide brand nylon sealed cable joint

  The manufacturer of Kunshan weiyide wiring equipment Co
, Ltd
supplies nylon waterproof cable connector Nylon cable connector nylon waterproof gland nylon (PA) refers to the plastic composed of polyamide resin
The cable joint made of nylon PA66 by Kunshan Weide has the following main advantages:
1
High mechanical strength, good toughness, high tensile and compressive strength
The tensile strength is close to the yield strength, which is more than twice that of ABS
It has strong absorption capacity for impact, stress and vibration, and its impact strength is much higher than that of ordinary plastics, and better than acetal resin

2
The fatigue resistance is outstanding, and the parts can still maintain the original mechanical strength after repeated bending for many times
PA is often used in places with obvious periodic fatigue effect, such as common escalator handrails and new bicycle plastic rims

3
Smooth surface, small friction coefficient and wear resistance
As a movable mechanical component, it has self lubrication and low noise
It can be used without lubricant when the friction effect is not too high; If lubricants are really needed to reduce friction or help heat dissipation, water, oil, grease, etc
can be selected

4
Corrosion resistant, very resistant to alkali and most salt liquids, also resistant to weak acids, engine oil, gasoline and other solvents, inert to aromatic compounds, and can be used as packaging materials for lubricating oil, fuel and so on

5
It is inert to biological erosion and has good antibacterial and mildew resistance

6
It is heat-resistant and has a wide temperature range
It can be used for a long time at - 450C to + 1000C, and the short-time withstand temperature can reach 120-1500c

7
Excellent electrical performance
It can be used as power frequency insulation material in dry environment, and has good electrical insulation even in high humidity environment
8
The parts are light in weight, easy to dye and easy to form
Due to its low melting viscosity, it can flow quickly
It is easy to fill the mold
After filling, the freezing point is high and can be shaped quickly
Therefore, the molding cycle is short and the production efficiency is high