Tianjin supplies diamond finishing pens and 1.0 carat diamond pens, which are durable and wear-resistant

Tianjin supplies diamond finishing pens and 1
0 carat diamond pens, which are durable and wear-resistant
  Qingdao shengxinjie brand natural diamond pen The grinding wheel dressing knife is suitable for grinding wheel dressing of different grinding machines
According to the pen head of diamond pen we produce, we call it single particle diamond dresser
It is a kind of diamond raw stone directly embedded on the substrate, and it is also the simplest dresser product
However, although the single point diamond pen is the simplest tool, there are some small differences
We can better operate the diamond dresser only by correctly understanding the direction and service conditions of the dresser, Better ensure product quality

  When dressing high-precision grinding wheel with single point diamond pen, we should ensure that the dressing range from fine grinding to rough grinding
It is recommended to use larger spherical diamond
Here are some matters we need to pay attention to:
  ① The single point diamond pen needs to be fixed on the fixture, the end face is perpendicular to the radial direction of the diamond grinding wheel, and the axial direction of the chain pen is 15 DEG with the radial direction of the grinding wheel; The included angle is better
When installing, the moving direction of the dresser points to the radial center of the grinding wheel
Even if the outer diameter of the grinding wheel becomes smaller, the installation angle of the dresser should not change, but the crystallization direction of diamond should be considered and the installation direction with less wear should be selected

  ② It can be used without grinding first
After one layer of diamond on the surface is used up, continue grinding until another layer of diamond is exposed, and then it can be used continuously

  ③ The feed rate during trimming is generally 0
02-0
04mm per stroke
The longitudinal cutting speed should be uniform
The general cutting speed is 100-500mm / min
during finishing, the cutting speed should be lower than that of rough trimming
The working stroke is 2-4 times and the empty stroke is 1-2 times

  ④ When dressing diamond grinding wheel, add coolant and quench after heat prohibition

  The above are some matters that our company suggests customers should pay attention to when using the single point diamond pen
Although it is a small one, it also has powerful functions
Only by grasping the method, the product quality can be guaranteed&# 8203;