Rolling door machine for fire shutter fjj617-3p - (xa800)

  Fjj series electric fireproof rolling shutter (door machine) is a new type of electric rolling shutter (door machine) developed on the basis of absorbing the advantages of a variety of domestic advanced models
The product has reliable quality, complete functions and convenient installation
It is an ideal supporting product for current buildings and a symbol of people's pursuit of modern life
This product can be used for both left and right installation forms
It can be equipped with fixed and movable double rail double support plate
The host is equipped with fuse installation support, which has wide applicability

1、 Working environment and conditions:
1
  The ambient air temperature varies with seasons,
2
  The relative temperature is 90% (25 ℃)

3
  Short time working system, each operation shall not exceed 5 minutes

2、 Main specifications and technical parameters of fjj series fireproof type:

model	lifting Door weight kg	lifting High degree m	rated Power Ｗ	rated electric current Ａ	output torque N n	large sprocket roll Cylinder speed r/min	Chain number	host Weight kg
380V 50Hz
600kg	600	6	250	1 3	412	5 8	10A	12
800-1000KG	800	9	550	2	607	5 3	10A	14
1500kg	1500	9	800	3	1617	4 6	12A	21

III
installation and commissioning
1
The products are uniformly manufactured according to the right installation method (from the inside to the outside)
If the left installation is required, the four locking screws of the brake object must be loosened, that is, rotate the shell of the hand zipper 180° Lock it again after, and the white (upper) and green (lower) colors of the button switch line must be reversed

2
The sprocket support plate can be installed horizontally or at 0 & DEG according to the specific needs as shown in Figure 3^ 45° Select installation and fixation within the scope
When the sprocket support plate is not installed horizontally, rotate the brake housing to make the ring hand zipper strip naturally and vertically downward
At the same time, pay special attention to the fit between the housing and the motor end cover
After confirming that there is no gap, tighten the four screws (diagonal evenly) to avoid excessive tightening force causing shell cracks and affecting the braking effect

The rolling shutter (door) machine shall be installed horizontally, the rolling shaft of the door curtain shall be concentric and horizontal, and the curtain sheet shall not be stuck

Adjust the chain sag to 3^6mm (before hanging the door curtain at the end of the rotating shaft)

It is forbidden to lift the motor lead bushing

The cross section of the external power line for the power supply of the rolling shutter (door) machine shall not be less than 1
0mm & sup2;

Pay special attention to prevent moisture and rain, and avoid short circuit of electric rolling shutter (door) motor, which will lead to burning out of rolling shutter (door) motor

Please connect the bottom line according to the regulations!