Repair and maintenance of electric sweepe

  1、 Precautions for use 1
The equipment shall be charged for 12 hours in the first three times and 6-8 hours in the later stage
Do not charge (overcharge) for a long time to avoid damaging the battery

2
If there are too long strips or filaments on the road, get off the vehicle and clean them manually
If they are not cleaned in time, they will burn the motor if they are wrapped around the main brush and side brush

3
If the ground dust is thick, it is necessary to: ① do not drive too fast
② Sweep back and forth several times
③ Use the water spray function

4
When there is muddy water on the ground, do not sweep the floor as far as possible, which will make the dust stick to the brush, increase the resistance of the motor, and cause the fault of jumping overload protection and burning insurance; If sweeping operation is carried out, the side brush and main brush shall be cleaned in time after completion

5
During cleaning, the brush shall not be too close to the wall and roadside, so as not to increase the resistance of the brush motor and cause the fault of jumping overload protection and burning insurance

6
When the equipment passes through the deceleration belt, stop sweeping the floor, raise the brush, put down the brush and continue cleaning
It is forbidden to reverse the equipment during cleaning

7
After the machine is completed, the power switch can be turned off only after the brush is fully restored

8
It is forbidden to clean on rainy and snowy days or water surface to avoid damaging the filter element and dust suction fan

9
It is forbidden to clean the vehicle body with water to avoid short circuit and burning the machine

10
Remember not to charge under high temperature and sun exposure
If the battery temperature is too high or there is a peculiar smell, stop charging immediately
11
If you don't work in winter, clean the water in the water tank of the machine to avoid freezing the water tank

12
After each cleaning operation for 1-2 hours, the dust shall be vibrated for 3-4 minutes to keep the filter element clean and enhance the dust collection effect

Warm tip: no matter how good the equipment is, it also needs maintenance
Regular maintenance of the machine can keep the machine in good condition and will not fall off the chain during use

2、 Maintenance precautions: turn off the power during operation!
1
After use every day, check whether there is winding on the side brush and main brush, and clean it in time if any, otherwise it is easy to cause excessive motor current and damage the motor

2
After use every day, check whether there is a large amount of soil on the dust suction port and the inner wall of the main brush
If any, clean it in time

3
The transmission part, chain, side brush landing gear, screw, main brush bearing, conveyor belt bearing seat, etc
shall be oiled and maintained every month to avoid rust

4
Clean the dust in the vehicle compartment every quarter, especially the dust in the substation box, and check and fix the main plugs, power supplies and screws

5
If the sweeper is not used for a long time, it shall be fully charged and placed in a place with shading and ventilation
It shall be charged at least once every 15 days
After charging, disconnect the power plug