Precautions during disassembly and assembly of band saw

  　  When the band saw is in use, it occasionally encounters some faults, some of which can be solved in time, but some faults may seriously affect the progress of the project
Therefore, in order to prevent some unnecessary faults, it is necessary to maintain the band saw in time, At the same time, pay more attention when disassembling the band saw machine, so that the band saw machine can be used for a longer time
1
When disassembling the components of the band saw, remove the locating pin and then carry out other disassembly work
When installing, install the locating pin first after the position is aligned, and then install other parts; When removing or replacing the bevel gear of the band saw, it is necessary to accurately adjust the meshing clearance of the bevel gear, check the contact spots of the bevel gear, and then fill in an appropriate amount of grease
2
When disassembling and installing the band saw, it is forbidden to strike the casting with force
When striking other accessories, wood blocks or red copper blocks shall be padded; During the disassembly of oil pipeline, the joint shall be protected
The disassembly times of oil pipeline joint shall be minimized to avoid oil leakage
3
Before the installation of the band saw, the parts need to be cleaned with kerosene, then wiped clean and coated with enough lubricating oil; At the same time, if damaged or worn parts are encountered, they also need to be replaced The above are the relevant matters needing attention during the disassembly and assembly of the band saw
Attention should be paid to both the replacement of parts and the disassembly and installation Source of information: http://www
pdssjcj
com/news/dongtai/show460
html