Industrial kiln sealing material ceramic fiber module has long high temperature resistance and long service life

The temperature in the industrial kiln has a great relationship with the sealing of the industrial kiln itself
If the sealing condition of the kiln is not good, it is likely to cause fire, and it will also have a great impact on the thermal insulation effect
Over time, it will cause irreparable loss to the service life of the kiln, which is also a matter that can not be underestimated for customers and friends
In order to avoid this kind of situation, general customers use the ceramic fiber module in the ceramic fiber material as the sealing tool
As we all know, the ceramic fiber module is very helpful for the insulation of the kiln
Now it is also useful for the sealing of the kiln
Because the ceramic fiber module is compressed, it will expand rapidly after construction, There is no gap at all, which achieves the dual effect of heat preservation and sealing
In addition, the sealing tightness of the kiln is also related to the density of ceramic fiber materials
The higher the density, the better the sealing effect
The density of Jinshi ceramic fiber module ranges from 200kg / m3 to 260kg / m3, and special density can also be customized according to the demand
The ceramic fiber module produced by Jinshi is always in the expansion state, and heating will not cause shrinkage
It is not only thermal insulation and sealing, but also greatly improves the service life of the kiln

Advantages of fiber module lining structure:
1
The anchor nail for the module is on the cold side of the lining (about 50 mm away from the steel plate) and far away from the hot Meng, which not only reduces the formation of the thermal bridge between the furnace gas and the furnace wall plate, but also reduces the material grade of the anchor, thus reducing the project cost

2
The fiber structure has good integrity, low fiber thermal conductivity, good overall thermal insulation effect, less fiber bulk density, less load on the whole steel structure, and the module does not contain binder
It will not react with flue gas to generate harmful gas during use, which can effectively protect the steel plate

3
The module itself does not contain water
After construction, it can be put into production without oven drying, which shortens the production cycle

4
Simple construction and short cycle: due to the elasticity of the refractory fiber module furnace lining, the compression can be predicted
Therefore, there is no need to leave expansion joints during construction
The construction personnel can work after basic training, and the construction technical factors have little impact on the thermal insulation effect of the furnace lining