Hubei Longkang PE blow molding integrated three compartment septic tank - manufacturer of sewage tre

  Product performance and characteristics: 1
The product is made of PE material, with acid resistance, alkali resistance, tensile resistance and compression resistance

2
No leakage for a long time and good sealing, so as to prevent the pollution caused by the leakage of groundwater in the traditional septic tank
At the same time, it improves the harm of foundation wet and soft settlement to buildings, and has good environmental protection benefits

3
The equipment adopts unique structural design and film hanging and filling department in Colleges and universities, with high removal rate, small floor area and flexible site selection
It is especially suitable for the reconstruction of sewer system and the establishment of septic tank in the old urban construction area

4
The product is light in weight and easy to transport
The product is formed as a whole without assembly and can be installed quickly

5
The product has high compressive strength, reasonable structural design, uniform compression and no deformation after many tests
It can be installed in the green lawn or under the road

6
It is convenient for installation and construction
It can be freely combined and installed according to the needs of the site
It can be put into use after installation

7
The treatment effect is good
The upper and lower staggered layers of the partition plate of this product are designed, and the original DC flashing is changed to circulation
With flashing, the substrate transfer is smooth and more biomass is intercepted
The sewage treatment capacity is higher than that of traditional manure with the same volume
The pool is more than doubled

8
Long service life, this product is resistant to humidity, oxidation, high and low temperature without deformation, acid and alkali, and can be used normally
Up to more than 60 years

9
It has the characteristics of light weight, high strength, good corrosion resistance, no leakage, no pollution, good formability and long service life
Both ends of the tank body are provided with water inlet and outlet pipes, and the tank top is provided with inspection wellhead
The tank is divided by compartment plate, and a circulating flashing device is set to increase the retention time of sewage and improve the corrosion effect

10
Economical and applicable, the cost is lower than the traditional brick septic tank and PE blow molding septic tank
It is an environmental protection product actively promoted by the urban construction department

Scope of application:
Preliminary treatment of domestic and fecal sewage of industrial and civil buildings such as residential buildings, office buildings, schools, sanatoriums, enterprise workshops and living rooms

working principle:
PE blow molding septic tank is a method to remove suspended organic matter from domestic sewage by using the principle of sedimentation and anaerobic fermentation
The sewage enters the septic tank and passes through 12 & mdash; After 24h precipitation, remove 50% & mdash; 60% suspended solids
After anaerobic digestion for more than 3 months, the precipitated sludge decomposes the organic matter in the sludge into stable inorganic matter, and the perishable raw sludge is transformed into stable cooked sludge, which changes the structure of the sludge, reduces the moisture content of the sludge, and is regularly removed for transportation, landfill or used as fertilizer

Product specification: 1
0m & sup3 1720*960*950mm   5-8 persons
1
5m³ 1850*980*1060mm   7-12 persons
  2
0m³ 1880*1130*1160mm   10-15 persons